This notice does not apply on and after 1 August 2019 (being the date on which the Land Transport (Measurement of Weight) Notice 2019 comes into force).

Clause 1A: inserted, on 1 August 2019, by clause 10(2) of the Land Transport (Measurement of Weight) Notice 2019 (LI 2019/174).

2 Interpretation

(1)

In this notice, unless the context otherwise requires,—

axle includes the wheel or wheels on the axle

dynamic axle-weigher means a device used to weigh successively each axle of a stationary vehicle or a moving vehicle

group of axles means any 2 or more consecutive axles of a vehicle or combination of vehicles

portable wheel-weigher means a portable device that—

(a)

is either mechanical or electronic; and

(b)

is designed to weigh a wheel of a stationary vehicle

semi-trailer means the trailing unit of an articulated vehicle

simple trailer means any trailer with a tow bar rigidly attached to the chassis or body of the trailer; but does not include a trailer equipped with a jinker pole

testing authority means any person referred to in section 147(2)(a) of the Land Transport Act 1998

weighbridge means a non-portable device that—

(a)

is either mechanical or electronic; and

(b)

is designed to weigh a single axle or simultaneously weigh 2 or more axles.

(2)

For the purposes of this notice, a semi-trailer is to be treated as a separate vehicle, whether or not it is readily detachable from the tractor unit.

(3)

References in this notice to the weight of 1 or more axles are to be read as if such references included the weight on any such axles.

Clause 2(1) testing authority: substituted, on 1 March 1999, by clause 2 of the Transport (Measurement of Weight) Amendment Notice 1999 (SR 1999/20).

3 Approved weighing devices

(1)

The weighing devices described in subclause (2) are approved for the purposes of recording or displaying the weight of a wheel, an axle, a group of axles, or a vehicle as required by the definition of the term weight in section 2(1) of the Land Transport Act 1998.

(2)

The approved weighing devices are—

(a)

any weighbridge or dynamic axle-weigher or portable wheel-weigher that has been tested by a testing authority and found to be accurate:

(b)

any weighbridge or portable wheel-weigher or dynamic axle-weigher that has been stamped with a mark of verification under the Weights and Measures Act 1987.

Clause 3(1): substituted, on 1 March 1999, by clause 3 of the Transport (Measurement of Weight) Amendment Notice 1999 (SR 1999/20).

Use of axle-weighers, weighbridges, and pits

4 Manner of use of dynamic axle-weighers

(1)

The site of any dynamic axle-weigher must be reasonably level along the length of the vehicle with the dynamic axle-weigher.

(2)

Those sections of the approaches to any dynamic axle-weigher on which one part of the vehicle is supported while another is being weighed must be reasonably level with the weighing platform.

(3)

The weight of an axle may be obtained by placing the axle on or slowly moving the axle over a dynamic axle-weigher and noting the weight recorded.

(4)

The weight, total weight, or gross weight of a group of axles may be obtained from a dynamic axle-weigher by adding the weights recorded in respect of each axle.

5 Manner of use of weighbridges

(1)

Those sections of the approaches to any weighbridge on which one part of a vehicle stands while another part is being weighed must be reasonably level with the weighing platform.

(2)

The weight of an axle may be obtained at a weighbridge by—

(a)

placing the axle alone on the weighing platform and noting the weight recorded; or

(b)

subtracting from the weight recorded when the axle is on the weighing platform at the same time as 1 or more other axles the weight recorded when the same 1 or more other axles are on the weighing platform alone.

(3)

The weight, total weight, or gross weight of a group of axles may be obtained at a weighbridge by—

(a)

placing the axles alone on the weighing platform and noting the weight recorded; or

(b)

subtracting from the weight recorded when the group of axles is on the weighing platform at the same time as 1 or more other axles the weight recorded when the same 1 or more other axles are on the weighing platform alone; or

(c)

adding the weights recorded on the axles and groups of axles making up the group for which the weight is required; or

(d)

using a combination of the methods referred to in paragraphs (a) to (c) in which each axle is taken into account only once.

6 Manner of use of pits containing portable wheel-weighers

(1)

The surface on which a vehicle stands while its axles are being weighed at a pit containing portable wheel-weighers must be reasonably level along the length of the vehicle with the platforms of the wheel-weighers.

(2)

The weight of an axle may be obtained at any such pit by placing the axle on the platforms of the wheel-weighers and then—

(a)

adding the weights recorded; or

(b)

if a summing cable is used, noting the weight recorded on one of the wheel-weighers joined by the cable.

(3)

The weight, total weight, or gross weight of a group of axles may be obtained at any such pit by adding the weights recorded in respect of individual axles.

Use of portable wheel-weighers

7 Portable wheel-weighers to be used on flat surface

(1)

The weight of the axles of a vehicle may be obtained by using portable wheel-weighers in accordance with this clause and clause 8 on a surface that is reasonably level along the length of the vehicle.

(2)

The portable wheel-weighers must be placed on the surface and the vehicle driven onto the platforms of the wheel-weighers.

8 Manner of weighing axles

(1)

The weight of an axle may be obtained by placing the axle on the platforms of the wheel-weighers and then—

(a)

adding the weights recorded; or

(b)

if a summing cable is used, noting the weight recorded on one of the wheel-weighers joined by the cable.

(2)

If a single axle is being weighed and the vehicle has 3 or more axles, any axles not being weighed must be raised to approximately the same level as the axle being weighed.

(3)

If a single axle is being weighed and the vehicle has 2 or more axles and is either a semi-trailer or a simple trailer, the point of attachment to the towing vehicle must be raised by approximately the same amount.

(4)

If 2 or more axles are being weighed and the vehicle has any axles not in that group of axles, the axles not in that group must be raised to approximately the same level as the axles being weighed.

(5)

If 2 or more axles are being weighed and the vehicle is either a semi-trailer or simple trailer, the point of attachment of the trailer to the towing vehicle must also be raised by approximately the same amount.

(6)

If this clause requires the point of attachment of a trailer to the towing vehicle to be raised, this may be done by raising the axles of the towing vehicle to approximately the same level as the axles being weighed.

(7)

The weight, total weight, or gross weight of a group of axles may be obtained by simultaneously placing all axles of the group on wheel-weighers and then—

(a)

adding the weights recorded; or

(b)

if a summing cable is used, noting the weight recorded on one of the wheel-weighers joined by the cable; or

(c)

using a combination of the methods referred to in paragraphs (a) and (b) in which each axle is taken into account only once.

9 Revocation

The Transport (Measurement of Weight) Notice 1988 (SR 1988/267) is consequentially revoked.

Dated at Wellington this 16th day of December 1997.

M S Morris,
Chairperson.

This notice was made by the Land Transport Safety Authority of New Zealand by a resolution passed at a duly constituted meeting held on the 16th day of December 1997.

Issued under the authority of the Legislation Act 2012.

Date of notification in Gazette: 18 December 1997.

Reprints notes

1 General

This is a reprint of the Transport (Measurement of Weight) Notice 1997 that incorporates all the amendments to that notice as at the date of the last amendment to it.

2 Legal status

Reprints are presumed to correctly state, as at the date of the reprint, the law enacted by the principal enactment and by any amendments to that enactment. Section 18 of the Legislation Act 2012 provides that this reprint, published in electronic form, has the status of an official version under section 17 of that Act. A printed version of the reprint produced directly from this official electronic version also has official status.

3 Editorial and format changes

Editorial and format changes to reprints are made using the powers under sections 24 to 26 of the Legislation Act 2012. See also http://www.pco.parliament.govt.nz/editorial-conventions/.

4 Amendments incorporated in this reprint

Land Transport (Measurement of Weight) Notice 2019 (LI 2019/174): clause 10

Transport (Measurement of Weight) Amendment Notice 1999 (SR 1999/20)

Transport (Measurement of Weight) Notice 1997